Lightronics TL4016 Instrukcja Użytkownika Pobierz pdf (Strona 3)

Page 3 of 6

TL – 4016 MEMORY CONTROL CONSOLE

Revision 1.4 OWNERS MANUAL 02/20/2005

www.lightronics.com

Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 TEL 757 486 3588

MOMENTAR

(

BUMP

)

BUTTONS

CHASE

RATE

CHASE

SELECTORS

CROSS

FADERS

Y MODE

SELECT

BLACKOUT

GRAND

MASTER

RECORD

Y FADERS

X FADERS

INITIAL SETUP

CHASE RESET (Resets chases to the factory programmed defaults): Remove power from the unit. Hold down

the CHASE 1 and CHASE 2 buttons. Apply power to the unit while holding these buttons down. Continue to hold

down the buttons for approximately 5 seconds then release.

SCENE ERASE (Clears all scenes): Remove power from the unit. Hold down the RECORD button. Apply power

to the unit while holding this button down. Continue to hold down the button for approximately 5 seconds then

release.

You should check the address settings of the dimmers before proceeding with TL-4016 operation.

OPERATING MODES

The TL-4016 is capable of operating in three different modes concerning the Y faders. Pressing the "Y MODE"

button changes the function of the Y (lower sixteen) faders. The selected mode is indicated by the Y mode LEDs.

The X (upper sixteen faders) ALWAYS control the level of channels 1 through 16.

z "CH 1-16" In this mode both the X and Y rows of faders control channels 1 through 16. The cross fader

is used to transfer control between X and Y.

z "CH 17-32" In this mode the Y faders control channels 17 through 32.

z "SCENE 1-16" In this mode the Y faders control the intensity of 16 recorded scenes.

1 2 3 4 5 6

Brak uwag

Lightronics TL4016 Instrukcja Użytkownika Strona 3